Off Road Forums On Planet4x4 banner

1 - 2 of 2 Posts

·
Registered
Joined
·
401 Posts
Discussion Starter · #1 ·
When I swapped the T-18 and put the Atlas behind it I replaced the output shaft to match the new input shaft for the atlas. In doing this, the tranny seems to be a lot tighter. The synchros don't seem to be working properly and when left in neutral it almost wants to crawl forward a bit. I think that the input shaft and the output shaft are push against each other so tight that it is causing this to happen and am wondering if time will smooth it all out or if I should pull it out and see what is happening. Anyone got an opinion?
 

·
Site Supporter
Joined
·
2,286 Posts
My samurai did that after I replaced the clutch everytime the clutch just needed adjusted :rotfl: :rotfl:
 
1 - 2 of 2 Posts
Top