Off Road Forums On Planet4x4 banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Has anybody done this conversion to a mid seventies K15 swb?

1976 GMC with a 400/th350/np203
Would like to put a 700r4 in the vehicle, but I also figured to scrap the np203, for a np 208, or possibly np241.

Would drive shaft alignments be off on with the 700r4/np208, or 241?

Would I need new drive shafts, or would I need to shorten, or lengthen the drive shafts I have now?

Crossmember: would this be an issue?

Is there an article out on this project?
 

·
Registered
Joined
·
66 Posts
it'll bolt right in dlies may have to be changed if you are putting in a slip yoke 208 I'm getting ready to swap a 350/203 for a 700r4/205
 
1 - 2 of 2 Posts
Top