Need to know how to tell a dana 60's apart

746 Views 1 Reply 2 Participants Last post by Sandman, Mar 18, 2004

BIG_BLAZER86

Discussion Starter · Mar 18, 2004

I have a front dana 60, and the guy I got it from said it was from a chevy, but when I went to but my front springs in the axle perches, I had to move the bottom of the spring to fit in the hole. Also I need to know if it's chevy or dodge to get brakes for it,can any one put some nice close up pictures of there dana 60 so I can get a good look at it Thanks Tony.

Save

1 - 2 of 2 Posts

Sandman

· #2 · Mar 18, 2004

I can post a pic of mine tonight.

The real giveaway is the KingPin ends. Fords and Dodges used ball joint ends. The Dodge will bolt in but the spring perches will be like 1/4" off on each side or something along those lines.

Save

1 - 2 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Home
Forums
4x4 Discussions
General 4x4 Talk

Top Contributors this Month