Off Road Forums On Planet4x4 banner
1 - 2 of 2 Posts

2,267 Posts
Discussion Starter · #1 ·
I have matching axles for sale off my YJ. I have 60s that need built and I need to plan for my winter project.

HPD44 78-79 f250 housing - so it has .5" thick tubes, not a thin tubed 44 housing
Narrowed to Waggoneer width, taking ~2.75" off each end
3of4 cromo shafts in the front. Warn stub shafts and Yukon shortside inner. I also have spares of some of these shafts.
Detroit full locker
Yukon 4.88s
WMS is 63"
It has dogde 44 outers to get 5on5.5" bolt pattern.
Machined flat tops
Highsteer arm on the pass side for the draglink.
Tie rod rides down low to protect the diff cover. : )
I have the tierod and draglink on there which are 1.5"x.25" wall DOM and Chevy Tie Rod Ends.
Warn locking hubs.


96 explorer 8.8
31spline shafts
Full Detroit
Crush sleeve eliminator
traction bar mount
traction bar
traction bar xmember
spacer changes from 5on4.5" to 5on5.5"


Matching set, bolt onto SOA wrangler
These are still on my rig and will be used until I find a buyer. Ask for pics of anything that you would like on these.

Nate Davidson
Meridian ID
or email nate at
1 - 2 of 2 Posts