Off Road Forums On Planet4x4 banner

1 - 7 of 7 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
I need a set of full-sized axles for my CJ-7. They need to be tough but Non-expensive. I hear junk yards are the way to go. I am also looking advice on which axles to get, I am planning to run 35" tires. Can anybody HELP ME!?!?
 

·
Registered
Joined
·
2,986 Posts
I have most of a Ford 9" rearend out of my Early Bronco. Housing, shafts 28 spline, and carrier. no r&P. Sell pretty cheap, let me know if you are interrested. These are great swaps.
 

·
DinoWagonMan!
Joined
·
2,732 Posts
!

in a month or so i will have a 9 1/4 rear and a 44 front out of a dodge. :thumb:

the rear is welded, but you could find a different carrier i'm sure! it has been good. it held up to my ramcharger and 39.5 Iroks. the front has the C A D system which has been locked in.

just ask if you want em! :thumb:
 

·
Registered
Joined
·
11 Posts
Lavacrawler said:
At one time Steve knew someone with a set of dana 44's front and rear out of a Scout that where pretty cheap. Might want to check with him. They would handle 35's easily.
If you are interested, I know where some D44's out of a Waggy can be had for @ $200 each axle, complete with rims.
 
1 - 7 of 7 Posts
Top