Off Road Forums On Planet4x4 banner

1 - 2 of 2 Posts

·
Site Supporter
Joined
·
2,286 Posts
Discussion Starter · #1 ·
Man I feel really stupid but I just busted off an easy out trying to get a broken grease zerk out. This is on the lower kingpin of my D60 so I would prefer to get it fixed sooner than later. Any suggestions? Here is what I have tried so far. Drilling it from the backside, broke 2 drill bits, tryed to punch it out, broke the punch tried welding a nut to it I can't get the weld to stick on the bottom ( of course it is 12:30) I will try this again though. Any help would be appreciated. :rotfl: :rotfl:
 

·
Registered
Joined
·
3,268 Posts
is this the part where I :rotfl: :rotfl: :rotfl: :rotfl: :rotfl:
before I offer to come over and help ya? :finger: :finger: :finger:
 
1 - 2 of 2 Posts
Top