Joined
·
130 Posts
I was at it all day.. ensuring EVERYTHING was even... level... centered.. you name it..
The motor mounts are fabbed, but ran into a slight problem with the steering shaft.. it intersects the driver mount
.... so I channeled it... its not done yet, but will be tomorrow.. the mount.. not the install..
I used the 360 mounts with the center of the 4 slots cut away, 1/4" plate with caddy pattern welded to the top of it.. then had to space it out 3/16" on each side off the framerails... not too bad...
I would like to thank Pete ( CrazyJeepman) for all the help and assistance he had provided me on this along the way...
I was able to retain the heater core with no mods.. this is due to the 3" bodylift... WHEW!!!
The HB unit clears with ease....
The motor mounts are fabbed, but ran into a slight problem with the steering shaft.. it intersects the driver mount
I used the 360 mounts with the center of the 4 slots cut away, 1/4" plate with caddy pattern welded to the top of it.. then had to space it out 3/16" on each side off the framerails... not too bad...
I would like to thank Pete ( CrazyJeepman) for all the help and assistance he had provided me on this along the way...
I was able to retain the heater core with no mods.. this is due to the 3" bodylift... WHEW!!!
The HB unit clears with ease....
