Off Road Forums On Planet4x4 banner

1 - 3 of 3 Posts

·
Site Supporter
Joined
·
2,286 Posts
Discussion Starter · #1 ·
Hey guys I need to know which part of the wiring harness I need to pull do I just need the engine loom or do I need part of the dash loom too. I am pulling this motor from a complete car where everything is still intact so I want to get everything I need to run the fuel injection :rotfl: :rotfl:
 

·
Registered
Joined
·
1,209 Posts
I would suggest pulling the dash also, you can toss it later if not needed.
You may/may not need the speed sensor off the speedometer.
 
1 - 3 of 3 Posts
Top