Off Road Forums On Planet4x4 banner
1 - 6 of 6 Posts

·
Registered
Joined
·
698 Posts
Discussion Starter · #1 ·
I am assisting a friend in the sale of this truck. It is a 1976 Chevy short bed half ton truck. It has a fresh 334 chevy motor (305 block with 400 crank and rods) built by Mark Kidd at Valley engine in Twin Falls. New 12 bolt rear end with 4.56 gears and new Eaton posi unit. This rear end was totally rebuilt not 1000 miles ago. This was done by Six States in Boise. It also has a 700R4 with NP205 transfer case. The Front end is a dana44 that needs the gears to match the rear. The front end contains 3.73 gears. The tranny needs rebuilt but everything else in or on the truck functions fine. Les Schwab has put new Tie Rod ends, bearings, hubs, etc in the front end. The body has some small dents and a litte rust. See Pics. Owner has all receipts. Asking $1850.00. You can reach him at 208-850-5697.

Jay's Truck 001.JPG

Jay's Truck 004.JPG

Jay's Truck 007.JPG

Jay's Truck 014.JPG

Jay's Truck 015.JPG
 

·
Registered
Joined
·
698 Posts
Discussion Starter · #2 ·
And a few more pics...
 

Attachments

·
Registered
Joined
·
698 Posts
Discussion Starter · #3 ·
Top!!
 

·
Registered
Joined
·
698 Posts
Discussion Starter · #4 ·
ttt!!
 

·
Registered
Joined
·
698 Posts
Discussion Starter · #5 ·
$1650....Someones gotta need a good chevy short box.
 

·
Registered
Joined
·
698 Posts
Discussion Starter · #6 ·
Top...He is down to $1550.00. This is a good running truck for fifteen hundred bucks.
 
1 - 6 of 6 Posts
Top